Passive Anti-Theft System Control Module

REMOVAL
1. Disconnect battery ground cable.
2. Remove integrated control panel.
3. Remove screw retaining passive anti-theft system control module to instrument panel.
4. Disconnect electrical connector and remove passive anti-theft system control module.

INSTALLATION
1. Install passive anti-theft system control module. Tighten retaining screws to 3.4-4.8 Nm (30-42 Lb-In).
2. Install an encoded ignition key (with correct vehicle mechanical key cut) into ignition switch and turn to RUN position to program the first key into control module.
3. To program additional keys, follow Spare Key Programming procedure.