Operation CHARM: Car repair manuals for everyone.
Home >> Ford >> 1997 >> Taurus V6-3.0L VIN U >> Repair and Diagnosis >> Powertrain Management >> Ignition System >> Ignition Coil >> Service and Repair >> Ignition Coil Pack
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Ignition Coil Pack

REMOVAL
1. Disconnect fuel charging wiring connectors from ignition coil and radio ignition interference capacitor.

Removing Ignition Wires At Coil Pack:






2. Disconnect ignition wires by squeezing locking tabs and twisting while pulling upward.
3. Remove four ignition coil retaining screws and remove ignition coil and radio ignition interference capacitor. Save radio ignition interference capacitor for installation with ignition coil.

INSTALLATION
1. Position ignition coil and radio ignition interference capacitor to ignition coil bracket.
2. Install retaining screws and tighten to 5-7 Nm (45-61 lb in).
3. Apply Silicone Dielectric Compound D7AZ-19A331-A (Motorcraft WA-10) or equivalent meeting Ford specification ESE-M1C171-A to all ignition wire boots.
4. Install each ignition wire connector to the proper terminal on the ignition coil. Make sure ignition coil boots are fully seated.
5. Connect engine control sensor wiring to the ignition coil and radio ignition interference capacitor.




pro multis · About Operation CHARM