Transmission Position Sensor/Switch: Service and Repair

Special Tools:

1. Raise and support vehicle.





2. Disconnect the transmission shift cable.
3. Disconnect the digital TR electrical connector.





4. Remove the manual control lever.
1. Remove the nut.
2. Remove the lever.

CAUTION: Discard outer manual control lever shaft nut. Do not reuse. The old nut will not retain torque specification.





5. Loosen the bolts.





6. Use the Digital Transmission Range (TR) Sensor Alignment Tool, to align the digital TR sensor slots.

NOTE: The manual control lever must be in the NEUTRAL position.





7. Tighten the bolts.





8. Install the manual control lever.
1. Position the manual control lever.
2. Install a new nut.





9. With the manual lever in OVERDRIVE connect the shift cable.
10. Install the electrical connector.
11. Remove the supports and lower the vehicle.