Installation

1. Install the oil pump screen cover and tube.

2. Apply a bead of silicone where the front cover an the rear crankshaft seal retainer fit to the engine block.
- Use Silicone Gasket and Sealant F6AZ-19562-A or equivalent meeting Ford specification WSE-M4G323-A6.

NOTE: If not secured within 4 minutes, sealant must be removed and the sealing area cleaned wit Metal Surface Cleaner F4AZ-19A536-RA or equivalent meeting Ford specification WSE-MSB392-A. Allow to dry until there is no sign of wetness, or 4 minutes, whichever is longer Failure to follow this procedure can cause future oil leakage.





3. Tighten the bolts in the sequence shown.
- Stage 1: Tighten to 2 Nm (18 inch lbs.)
- Stage 2: Tighten to 20 Nm (15 ft. lbs.)
- Stage 3: Tighten an additional 60 degrees

NOTE: Be sure to tighten the bolts in three stages.





4. Tighten the front engine support insulators.
5. Connect the battery ground cable.
6. Fill the engine with oil.
- Use Motorcraft Engine Oil XO-5W30-QSP or equivalent meeting Ford specification WSS-M2C153-G.

7. Fill the cooling system