Safety Belt Without Anchor Plate Thread Damage
Replacement of the Weld Nut and/or Reinforcement1. Expose the suspect anchor point.
NOTE: If the B, C, or D-pillar safety belt anchor nuts, bolts, or reinforcements are stripped or missing, they should be replaced with a new nut/reinforcement plate.
2. Drill out two 8 mm (5/16 in) diameter access holes adjacent to the weld nut clearance hole.
3. Thread a length of copper welding wire through the clearance hole and position to secure the weld nut and washer.
4. Use a MIG Wire Feed Welder and plug weld a 7/16 inch weld nut and standard washer in place at the two 8 mm (5/16 in) holes.
5. Metal finish the welded area as required.
6. Perform the Functional Test. Component Tests and General Diagnostics