Transmission Position Sensor/Switch: Service and Repair
REMOVAL1. Disconnect battery ground cable.
2. Raise vehicle on hoist.
3. Disconnect electrical harness from transmission range (TR) sensor.
4. Remove nut retaining manual control lever to manual control lever shaft. Remove manual control lever.
5. Remove two retaining bolts.
6. Remove transmission range (TR) sensor.
INSTALLATION
1. Place shift control selector lever in the Neutral position.
2. Install transmission range (TR) sensor and loosely install two retaining bolts.
3. Align TR slots using Transmission Range/Manual Lever Position Sensor Alignment Tool T92P-70010-AH.
4. Tighten retaining bolts to 9-12 Nm (80-106 inch lbs.) and remove tool.
5. Connect electrical harness to manual lever position sensor.
6. Install transaxle manual control lever. Install retaining nut and tighten to 16-22 Nm (12-16 ft. lbs.).
7. Connect battery ground cable.
8. Check for proper operation with parking brake engaged. The engine should start only in PARK or NEUTRAL.