Connecting Rod

GENERAL SPECIFICATIONS
Connecting Rod Piston Pin Bore Diameter 22.94-22.98 mm (0.9096-0.9112 in.)
Crankshaft Bearing Bore
Diameter 61.635-61.655 mm (2.4266-2.4274 in.)
Out-of-Round Limit - Piston Pin Bore 0.003 mm (1)
Taper Limit Piston Bore 0.003 mm
Length (Center to Center) 154.66-154.74 mm
Alignment (Bore-to-Bore Max. Diff.)
Twist 0.075 per 25 mm (0.003 per in.)
Bend 0.04 per 25 mm (0.0016 per in.)
Side Clearance (Assembled to Crank)
Standard 0.11-0.49 mm
Service Limit 0.36 mm Max. (0.014 in. Max)

(1) Smaller than pin bore measured along center to center axis.

TORQUE SPECIFICATIONS
Connecting Rod Cap Bolt (2)

(2) Tighten in two steps:
- 40-45 Nm (30-34 Ft. Lbs.)
- Rotate an additional 90-120 degrees