Front
HEIGHT STOP ADJUSTMENT1. Remove front door trim panel and front door inside panel sound insulator.
2. Lower front door window glass approximately 75 mm (3 Inches) from full up position.
3. Loosen nut and washer assemblies retaining the window regulator equalizer arm bracket to front door inner panel.
4. With front door open, place hands on each side of front door window glass and pull front door window glass fully rearward into front door glass top run.
5. Tighten nut and washer retaining the front of the window regulator equalizer arm bracket. Apply a downward pressure on the window regulator equalizer arm bracket. If the hole is a vertical slotted hole, make sure that the nut and washer retaining the rear of the window regulator equalizer arm bracket is positioned at the bottom of the slot as you apply a downward pressure on the window regulator equalizer arm bracket. Then tighten nut and washer to 7-10 Nm (62-88 Lb-In).
6. Cycle front door window glass to verify proper operation.