Cruise Control Switch: Service and Repair

Special Tool(s)


REMOVAL
1. Remove the driver side air bag module.







2. Remove the steering wheel bolt.







3. Use (A) Steering Wheel Puller to remove the (B) steering wheel.







4. Tape the (A) air bag sliding contact to the (B) steering column housing to prevent misalignment.







5. Remove the (A) screws from the back of the steering wheel and remove the (B) steering wheel trim.







6. Remove the (A) screws and the (B) speed control actuator switch.

INSTALLATION







1. Install the (A) speed control actuator switch and the (B) screws.







2. Position the (A) steering wheel trim and install the (B) screws.







3. Remove the tape holding the air bag sliding contact in position.







4. Install the steering wheel.

NOTE:
- Ensure the steering wheel is correctly aligned prior to installing it on the steering column.
- Route the wire connectors through the steering wheel trim cover prior to installing the steering wheel.







5. Install the steering wheel bolt. Tighten bolt to 46-63 Nm (34-46 lb-ft).
6. Install the driver side air bag module.

WARNING: When carrying a live air bag, make sure the bag and trim cover are pointed away from your body. In the unlikely event of an accidental deployment, the bag will then deploy with minimal chance of injury.