Limited and 6-Way Power

REMOVAL

WARNING:
^ ALWAYS WEAR SAFETY GLASSES WHEN REPAIRING AN AIR BAG SUPPLEMENTAL RESTRAINT SYSTEM (SRS) VEHICLE AND WHEN HANDLING AN AIR BAG MODULE. THIS WILL REDUCE THE RISK OF INJURY IN THE EVENT OF AN ACCIDENTAL DEPLOYMENT.
^ AFTER DEPLOYMENT, THE AIR BAG SURFACE CAN CONTAIN DEPOSITS OF SODIUM HYDROXIDE, A PRODUCT OF THE GAS GENERANT COMBUSTION THAT IS IRRITATING TO THE SKIN. WASH YOUR HANDS WITH SOAP AND WATER AFTERWARD.

CAUTION: Use care when handling the seat and track assembly. Dropping the assembly or sitting on a seat not secured in the vehicle may result in damaged components.

1. Remove the front seat.

NOTE: Be sure to read and follow all air bag warnings.

2. Place the seat on a clean workbench.







3. Remove the safety belt buckle slide bar.
1. Remove the nut.
2. Remove the bolt.
3. Remove the safety belt buckle slide bar.







4. Disconnect the seat track wiring harness electrical connectors.
^ If equipped, disconnect the memory seat module electrical connectors.
^ Disconnect the seat track motor electrical connectors.







5. Remove the seat track.
1. Remove the bolts.
2. Remove the seat track.

INSTALLATION












1. To install, reverse the removal procedure.
^ Check the restraint system for proper operation.
^ If equipped, prove out the air bag system.

NOTE: When installing the power seat track, start at the corner with the round hole and work around the seat base in a horseshoe pattern.