Trunk / Liftgate Handle: Service and Repair

Heavy Duty Riveter:

SPECIAL TOOL(S)

REMOVAL
1. Remove the liftgate trim panel.







2. Remove the liftgate watershield.







3. Remove the vent panel.
1. Remove the pin-type retainers.
2. Remove the vent panel.







4. Disconnect the outside liftgate handle actuating rod.
1. Open the clip.
2. Disconnect the outside liftgate handle actuating rod.







5. Remove the license plate lamp shield.
1. Remove the screws.
2. Remove the license plate lamp shield.







6. Remove the outside liftgate handle.
1. Drill out the rivets.
2. Remove the outside liftgate handle.

INSTALLATION







1. To install, reverse the removal procedure.
- Use Heavy-Duty Riveter to install the rivets.