Ride Height - With Automatic Ride Control

NOTE: A New Generation STAR (NGS) tester or equivalent scan tool must be used to perform this operation. Ford does not provide a procedure to reset the ride height without this equipment.

1. Connect New Generation Star (NGS) Tester to the Data Link Connector (DLC).
2. Select the RIDE CONTROL OUTPUT screen and turn on the following solenoids to vent the entire system of air and to lower the vehicle to its lowest attainable height:
- FRNT FILL (front fill solenoid).
- REAR FILL (rear fill solenoid).
- GATE VALVE (gate solenoid).
- VENT (vent solenoid).
3. Close all doors including the liftgate and liftgate window.
4. Reopen any door (to ensure that the height will not change until the internal electronic calibration is complete).
5. Park the vehicle on a flat surface.
6. From the function menu, quickly select RIDE HEIGHT CALIBRATION.
7. Note the warning on the NGS Tester screen and follow the directions.
8. Lower the vehicle and clear all stored Diagnostic Trouble Codes (DTCs).