Removal and Installation

Removal

WARNING: The power brake booster should not be carried by the accumulator, nor should it ever be dropped on the accumulator. Check the snap ring on the accumulator for correct seating before the power brake booster is used. The accumulator contains high-pressure nitrogen gas and can be dangerous if mishandled.

WARNING: If the accumulator is to be disposed of, it must not be exposed to excessive heat. Before discarding the accumulator, drill a 1.6 mm (1/16 inch) diameter hole in the end of the accumulator can to relieve the gas pressure. Always wear safety glasses when performing this operation.

1. With the engine off, depress the brake pedal several times to discharge the accumulator.
2. Disconnect the battery ground cable.





3. Disconnect the fluid level sensor connector.





4. Remove the clutch cable bracket bolt.





5. Disconnect the brake tubes.





6. Disconnect the power steering return line hose.





7. Disconnect the power steering pressure lines.





8. Remove the self-locking pin.





9. Remove the stoplight switch and the brake booster push rod from the brake pedal pin.





10. Remove the power brake booster nuts.





11. Remove the power brake booster nut.





12. Remove the booster.

Installation

















1. Follow the removal procedure in reverse order.
- Install new Teflon(R) seals on the power steering pressure fittings.
- Bleed Hydro-Boost.