Crankshaft Position Sensor: Service and Repair

REMOVAL
1. Disconnect battery ground cable.
2. Disconnect engine control sensor wiring from the Crankshaft Position sensor (CKP sensor).







3. Remove crankshaft position sensor retaining bolts and remove crankshaft position sensor.

INSTALLATION
1. Make sure crankshaft position sensor mounting surface is clean.
2. Position crankshaft position sensor and install retaining bolts. Tighten to 5-7 N.m (45-61 Lb-In).

CAUTION: Do not overtighten crankshaft position sensor retaining bolt or damage to crankshaft position sensor may occur.

3. Properly route engine control sensor wiring and connect electrical connector to crankshaft position sensor.
4. Connect battery ground cable.