Engine Controls, Electronic

Camshaft Position Sensor:

REMOVAL
1. Disconnect battery ground cable.
2. Disconnect engine control sensor wiring from Camshaft Position sensor (CMP sensor).
3. Remove camshaft position sensor retaining bolt and remove camshaft position sensor from engine.

INSTALLATION
1. Make sure camshaft position mounting sensor surface is clean and that camshaft position sensor O-ring is in proper location on camshaft position sensor.
2. Position camshaft position sensor onto engine and install retaining bolt. Tighten retaining bolt to 8-12 N.m (71-106 Lb-In).

CAUTION: Do not overtighten camshaft position sensor retaining bolt or damage to camshaft position sensor or engine mounting surface may occur.

3. Connect engine control sensor wiring to camshaft position sensor.
4. Connect battery ground cable.