Left

REMOVAL
1. Remove CJB fuse 6 (15 A).
2. Remove the rear seat.
3. Remove the left upper quarter trim panel.
4. Remove the left lower quarter trim panel.
5. Remove the upper and lower A/C ducts.







6. Release the position sensor from the actuator drive assembly.







7. Disconnect the connector.
8. Release the position sensor wiring from the harness and remove the position sensor.

INSTALLATION
1. Route the position sensor wiring into the harness tie downs and behind the actuator drive assembly.







2. Install the position sensor into the actuator drive assembly. Make sure both tabs snap into place.







3. Connect the connector
4. Install the upper and lower A/C ducts.
5. Install the left lower quarter trim panel.
6. Install the left upper quarter trim panel.
7. Install the rear seat.
8. Install CJB fuse 6 (15 A).
9. Initialize both of the power sliding doors.
^ Press the overhead console switch to open the left power sliding door to the full open position. Press the same switch to close the left power sliding door to the full closed position.
^ Press the overhead console switch to open the right power sliding door to the full open position. Press the same switch to close the right power sliding door to the full close position.

NOTE:
^ Make sure that the power sliding doors are fully closed and latched.
^ Make sure that the power sliding doors are unlocked.