Ignition Cable: Service and Repair

Spark Plug Wire Remover:

Special Service Tool(s)

REMOVAL

Spark Plug Wire Remover:

1. Use the special tool with a twisting motion to pull the spark plug wire off the spark plug.

CAUTION
^ Spark plug wires must be connected to the proper ignition coil terminal. Mark spark plug wire locations before removing them.
^ It is important to twist the spark plug wire boots while pulling upward to avoid possible damage to the spark plug wire.







2. Disconnect the spark plug wire from the ignition coil by squeezing the locking tabs and twisting while pulling upward.
3. Open the spark plug wire separators and remove the spark plug wire.

INSTALLATION
1. To install, reverse the removal procedure.

CAUTION: Be sure to orient the spark plug boots so the spark plug wires do not contact the exhaust manifold.

NOTE: Apply Silicone Brake Caliper Grease and Dielectric Compound D7AZ-19A331-A or equivalent meeting Ford specification ESE-M1C171-A to the inside of the spark plug and ignition coil boots of the spark plug wire.