Transmission Position Sensor/Switch: Service and Repair

Special Tools:

Removal
1. Set the parking brake.
2. Place the transaxle range selector lever in neutral.
3. Disconnect the battery ground cable.
4. Remove the engine air cleaner assembly.





5. Disconnect the Digital Transmission Range (TR) sensor electrical connector.





6. Disconnect the shift cable.





7. Remove the manual control lever.





8. Remove the digital TR sensor.

Installation
1. Verify that the transaxle range selector lever is in neutral.





2. Install the digital TR sensor and loosely install the bolts.





3. Using the special tool, align the digital TR sensor.





4. Install the manual control lever and nut.





5. Connect the shift cable.
6. Verify that the shift cable is properly adjusted.





7. Connect the digital TR range sensor electrical connector.
8. Install the engine air cleaner assembly.

9. Note: When the battery is disconnected and reconnected, some abnormal drive symptoms may occur while the vehicle relearns its adaptive strategy.

Connect the battery ground cable.
10. Check for correct vehicle operation.