Keyless Entry (Driver Door Module) Module

REMOVAL
1. Disconnect the battery ground cable.

CAUTION:
^ Prior to removal of module, it is necessary to upload module configuration information to New Generation STAR (NGS) Tester. This information needs to be downloaded into the new module once installed. Refer to Information Bus.
^ Electronic modules are sensitive to electrical charges. If exposed to these charges, damages may result.

2. Lower the glove compartment.







3. Remove the remote keyless entry [driver door module] module.
1. Disconnect the electrical connector.
2. Remove the nuts.

INSTALLATION
1. To install, reverse the removal procedure.

CAUTION: Once the new module is installed, it is necessary to download the module configuration information from the NGS Tester into the new module. Refer to Information Bus.

NOTE: When the battery is disconnected and reconnected, some abnormal drive symptoms may occur while the vehicle relearns its adaptive strategy. The vehicle may need to be driven 16 km (10 mi) or more to learn the strategy.