Regular Cab

SPECIAL SERVICE TOOL(S)

REMOVAL

NOTE: Safety belt buckles, height adjusters, center adjust tongues and belts and retractors can be replaced separately. However, if a safety belt assembly was in use during a collision, the belt and retractor must be replaced as well as the center adjust tongue and belt and buckle assembly or the center adjust tongue and the cable and buckle assembly. When replacing safety belts and buckles, height adjusters, safety cables and buckles, center adjust tongues and belts and retractors, use only the replacement parts specified in the Ford Master Parts Catalogs for the make and model of the vehicle being serviced. Safety belt assemblies must not be interchanged between vehicle models.







1. Remove the shoulder strap guide.
1 Position the shoulder strap guide cover up.
2 Remove the shoulder strap guide nut.
3 Remove the shoulder strap guide.
2. Remove the front door scuff plate and the rear corner trim panel.







3. Remove the front safety belt retractor.
1 Use the Seat Belt Bolt Bit to remove the bolt.
2 Remove the front safety belt retractor.







4. Remove the front safety belt anchor.
1 Use the Seat Belt Bolt Bit to remove the bolt.
2 Remove the front safety belt anchor.

INSTALLATION

















1. Follow the removal procedure in reverse order.

NOTE:
^ Make sure the safety belt webbing is not twisted prior to installation.
^ Make sure to tighten nuts and bolts to specification.

2. Check the restraint system for correct operation.