Multifunction Switch Replacement

MULTIFUNCTION SWITCH REPLACEMENT

1. Turn the ignition switch lock cylinder to the RUN position. Then, push the ignition switch lock cylinder release tab with a punch while pulling out the ignition switch lock cylinder.

2. Remove the tilt wheel handle by turning the handle counterclockwise (it equipped).

3. Remove the upper to lower steering column shroud retaining screws and remove the shrouds.





4. Remove the two (2) multifunction switch retaining screws and disconnect the electrical connectors. See Figure 4.





5. Inspect the multifunction switch electrical connector pins to make sure they are not loose or pushed out in the connectors. See Figure 5.

6. Connect the new multifunction switch, making sure the electrical connectors snap into place and are fully seated.

7. Install the new switch. Tighten the screws to 3 Nm (27 lb-in).

8. Install the upper and lower steering column shrouds. Tighten the screws 10 1 Nm (9 lb-in).

9. Install the tilt wheel handle (if equipped).

10. Install the ignition switch lock cylinder.

11. Connect the battery ground cable, reprogram the radio stations and set the clock.