Do you have access to Mitchell1 Prodemand? If you are willing to share user/password (we can pay $250), please get in contact with us ASAP: email operation-charm [[at]] tuta.io or click to submit anonymously

System Specifications

Engine General Specifications

Tightening Specifications

Install the cylinder head on the head gasket and loosely install the bolts.
- LH shown; RH similar.

Note: Be sure to tighten the bolts in three stages.

Tighten the LH bolts in the sequence shown.
- Stage 1: Tighten to 37-43 Nm (27 32 ft. lbs.).
- Stage 2: Tighten an additional 85 degrees to 95 degrees.
- Stage 3: Tighten an additional 85 degrees to 95 degrees.