Keyless Entry Remote Transmitter Programming

NOTE: All remote transmitters are programmable and must be set at the same time.

1. Make sure that the anti-theft system is not armed or triggered.
2. Turn the ignition switch from OFF to RUN four times within three seconds, ending in RUN. The locks will then lock and then unlock, confirming program mode has been entered.
3. Press any button on a key less entry remote transmitter, and the door will lock and then unlock to confirm that each remote transmitter has been programmed.
4. If additional keyless entry remote transmitters are to be programmed, repeat Step 2 within 7.5 seconds.
5. To exit program mode, turn the ignition to START or wait 7.5 seconds.