Driver Door Module

REMOVAL
1. Disconnect the battery ground cable.

CAUTION: Prior to removal of the Driver Door Module (DDM), it is necessary to upload module configuration information to a diagnostic tool. This information needs to be downloaded into the new module once installed.

2. Remove the driver door trim panel.







3. Remove the driver door module (DDM).
1 Disconnect the electrical connector.
2 Remove the screws.
3 Release the locking tab.

INSTALLATION
1. To install, reverse the removal procedure.
^ Check for correct operation.

CAUTION: Once the new DDM is installed, it is necessary to download the module configuration information from the diagnostic tool into the new module.