Cruise Control Servo: Service and Repair

REMOVAL
1. Disconnect the battery ground cable.







2. Disconnect the speed control actuator cable from the throttle control lever.
1 Disconnect the speed control actuator cable end from the throttle control lever.
2 Disengage the speed control actuator cable sleeve from the retainer.
3 Remove the retainer.







3. Disconnect the speed control servo electrical connector.







4. Remove the speed control actuator cable cap.
1 Depress the speed control actuator cable cap retaining tab.
2 Rotate the speed control actuator cable cap counterclockwise.







5. Remove the speed control actuator cable.
^ Move the spring tab away from the speed control cable end to release the cable from the actuator.







6. Remove the speed control servo.
1 Remove the bolts.
2 Remove the speed control servo.

INSTALLATION












1. To install, reverse the removal procedure.

NOTE: When the battery is disconnected and reconnected, some abnormal drive symptoms may occur while the vehicle relearns its adaptive strategy.