Rear Door Window Motor: Service and Repair

Heavy Duty Riverter:

SPECIAL TOOL(S)

REMOVAL

NOTE: The window regulator and motor are removed as an assembly.

1. Remove the rear door trim panel.
2. Remove the rear door radio speaker.
3. Remove the rear door watershield.
4. Raise and support the rear door window glass to the full up position.

CAUTION: Support the window glass to avoid damage.







5. Disconnect the power window motor electrical connector.







6. Remove the window glass to regulator nuts.







7. Remove the motor and window regulator assembly.
1 Drill out the rivets.
2 Remove the motor and window regulator assembly.







8. Remove the power window motor
1 Remove the bolts.
2 Remove the power window motor.

NOTE: Prior to motor removal, make sure the regulator arms are in a fixed position to prevent counterbalance spring unwind.

INSTALLATION












1. To install, reverse the removal procedure.
^ Use Heavy Duty Riveter to install the new rivets.
^ Cycle the door glass to make sure of gear engagement.