Intermediate Band Adjustment

1. Disconnect the battery ground cable.
2. Raise and support the vehicle.





3. Remove the shift cable.
1. Disconnect the shift cable from the manual control lever.
2. Remove the shift cable from the bracket.
4. Remove the digital transmission range (TR) sensor.





5. CAUTION: Do not allow the screw to back out. Band strut could fall out of position.

CAUTION: Throw the locknut away. The locknut is not reusable for assembly.

Remove and discard the locknut.





6. CAUTION: Install, but do not tighten, a new locknut on the screw. Apply petroleum jelly to the locknut seal.

CAUTION: The intermediate servo must be installed prior to band adjustment.

Note: The wrench will click at the specified torque. Install new locknut, do not tighten at this time.

Tighten the screw using the Band Adjuster Wrench Kit and back off the screw exactly two (2) turns and hold that position.





7. Tighten the intermediate band locknut.
1. Hold the screw stationary.
2. Tighten the intermediate band locknut.





8. Install the digital TR sensor.
1. Position the digital TR sensor.
2. Loosely install the screws.





9. CAUTION: Tightening one screw before tightening the other may cause the sensor to bind or become damaged.

Note: The manual lever must be in the neutral position.

Using the special tool, align the digital TR sensor and tighten screws in an alternating sequence.





10. Install the manual control outer lever.
1. Install the manual control outer lever.
2. Install the manual control outer lever nut.





11. Connect the digital transmission range (TR) sensor electrical connector.





12. Connect the shift cable.
1. Connect the shift cable to the bracket.
2. Connect the shift cable to the manual control lever.
13. Verify that the shift cable is adjusted.
14. Lower the vehicle.
15. Connect the battery ground cable.