Windshield Washer Pump: Service and Repair
REMOVAL1. Disconnect the windshield washer hose from the windshield washer pump.
NOTE: To prevent spilling windshield washer fluid, drain the windshield washer reservoir before removal.
2. Disconnect the coolant overflow hose from the engine coolant overflow reservoir and plug the outlet of the reservoir.
3. Disconnect the windshield washer reservoir pump electrical connector and low level washer fluid electronic sensor connector, if equipped.
4. Remove the engine air cleaner; refer to Fuel Delivery and Air Induction.
5. Remove the two screws and two nuts and remove the windshield washer reservoir.
6. Remove the windshield washer pump.
NOTE: Make sure not to tear the rubber grommet during disassembly.
INSTALLATION
1. To install, reverse the removal procedure.
NOTE: The windshield washer reservoir, windshield washer pump and the windshield washer reservoir fluid level sensor are replaced separately.