Cruise Control Servo: Service and Repair

REMOVAL







1. Disconnect the speed control servo electrical connector.







2. Remove the speed control actuator cable cap from the speed control servo.
^ Push the locking arm on the speed control actuator cable cap then rotate the cap counterclockwise.







3. Disconnect the speed control core wire end from the speed control servo pulley.
1 Depress the spring retainer.
2 Slide the core wire end out of the speed control servo pulley.







4. Remove the speed control servo bracket bolt.







5. Remove the speed control servo.

INSTALLATION







1. Install the speed control servo bracket bolt.







2. Insert the speed control cable slug into the speed control servo pulley slot.
1 Gently compress the speed control servo spring.
2 Insert the speed control cable slug into the speed control servo pulley slot.







3. Release the compressed spring while aligning the speed control actuator cable cap tabs with the slots in the speed control servo housing.

WARNING: INCORRECT WRAPPING OF THE SPEED CONTROL ACTUATOR CABLE AROUND THE SPEED CONTROL SERVO PULLEY MAY RESULT IN A HIGH IDLE CONDITION.

NOTE: Make sure the rubber seal is fully seated onto the speed control actuator cable cap.







4. Rotate the speed control actuator cable cap until the locking arm engages.