Without Side Air Bag

Safety Belt Bolt Bit:

SPECIAL TOOL(S)

REMOVAL
1. Position the driver seat rearward.







2. Remove the driver seat front track to floor bolts.
3. Move and tilt the front seats to their highest and most forward position.
4. Disconnect the battery ground cable and wait at least one minute.







5. Disconnect the driver seat.
1 Remove the tie-strap.
2 Disconnect the driver seat side air bag delete resistor electrical connector.
3 Disconnect the driver seat power seat track electrical connector.







6. Remove the safety belt buckle support bolt cover plug.







7. Using the special tool, remove the safety belt buckle support bolt.







8. Disconnect the safety belt warning indicator electrical connector.







9. Remove the driver seat rear bolt trim covers.







10. Remove the driver seat rear bolts.
11. Remove the driver seat from the vehicle.







12. Remove the safety belt buckle support.
1 Remove the nut.
2 Remove the bolt.
3 Remove the safety belt buckle support.







13. Disconnect the seat track wiring harness electrical connector.







14. Remove the seat track.
1 Remove the bolts.
2 Remove the seat track.

INSTALLATION







1. Install the seat track.

NOTE: When installing the power seat track, start at the corner with the round hole and work around the seat base in a horseshoe pattern.







2. Connect the seat track wiring harness electrical connectors.







3. Install the safety belt buckle support onto the slide bar.
1 Position the safety belt buckle support onto the slide bar.
2 Using the special tool, install the safety belt buckle support bolt.
3 Remove the safety belt buckle support from the vise.







4. Install the safety belt buckle slide bar onto the seat.
1 Position the safety belt buckle slide bar to the seat.
2 Install the nut and bolt.
5. Position the driver seat into the vehicle. Install all the seat track to floor bolts and hand-tighten them.

CAUTION: Use care when handling the seat and track assembly. Dropping the assembly or sitting on a seat not secured in the vehicle may result in damaged components.







6. Connect the driver seat side air bag delete resistor and power seat electrical connectors.
1 Connect the driver seat power seat track electrical connector.
2 Connect the driver seat side air bag delete resistor electrical connector.
3 Tie-strap the wire harness.
7. Connect the battery ground cable.
8. Position the driver seat rearward.







9. Tighten the driver seat front track to floor bolts in the sequence shown.
1 Tighten the front inboard bolt.
2 Tighten the front outboard bolt.
10. Move and tilt the driver seat to its highest and most forward position.







11. Tighten the driver seat rear track to floor bolts in the sequence shown.
1 Tighten the rear inboard bolt.
2 Tighten the rear outboard bolt.







12. Install the driver seat rear track bolt covers.







13. Connect the safety belt warning indicator electrical connector.







14. Using the special tool, install the safety belt buckle support bolt.







15. Install the safety belt buckle support bolt cover.
16. Check the restraint system for correct operation.