Brake Disc Shield

Shield

Removal
1. Remove the rear wheel disc brake adapter.





2. Remove the rear wheel disc brake shield.
1 Drill out the rivet, (if present).
2 Remove the rear wheel disc brake shield.

Installation





1. NOTE: Because the rear wheel disc brake shield is held in position by the four rear wheel disc brake adapter bolts, a new rivet is not required.

Seal the rivet hole with Clear Silicone Rubber F7AZ-19554-CA or equivalent meeting Ford specification ESB-M4G92-A, and install the rear wheel disc brake shield.
2. Install the rear wheel disc brake adapter.