Second Row
Blower Motor - Second RowREMOVAL
1. Remove the floor console.
2. Remove the coin tray.
3. Remove the screws and the console insert.
4. Remove the screw and the console lid.
5. Remove the screws.
6. Open the rear cupholder. Remove the screws.
7. Remove the two screws.
8. Disengage the retaining clips. Remove the console rear finish panel.
9. Remove the screws.
10. Disconnect the electrical connectors. Disengage the pin-type retainer.
11. Disconnect the air distribution door linkage from the second row climate control assembly arm. Remove the second row climate control assembly.
CAUTION: Do not attempt to bend the second row climate control assembly arm.
12. Remove the screws and the console rear air distribution duct.
13. Remove the nine screws and the console liner.
14. Remove the nuts.
15. Remove the screws.
16. Remove the two screws.
17. Disconnect the blower motor resistor.
18. Disengage the pin-type retainer.
19. Slide the console reinforcement rearward. Partially remove the blower motor and air distribution duct assembly.
20. Disconnect the blower motor electrical connector.
21. Remove the screws. Remove the blower motor assembly from the console air distribution duct.
INSTALLATION
1. Align the blower motor assembly with the console air distribution duct. Install the screws.
2. Connect the blower motor electrical connector.
3. Position and align the studs of the blower motor and air distribution duct assembly to the console reinforcement.
4. Slide the console reinforcement forward.
5. Engage the pin-type retainer.
6. Connect the blower motor resistor electrical connector.
7. Install the two screws.
8. Install the two screws.
9. Install the nuts.
10. Install the console liner and the nine screws.
11. Install the console rear air distribution duct and the screws.
12. Connect the air distribution door linkage to the second row climate control assembly arm.
CAUTION: Do not attempt to bend the second row climate control assembly arm.
13. Connect the electrical connectors. Engage the pin-type retainer.
14. Position the second row climate control assembly. Install the screws.
15. Align the console rear finish panel to the floor console. Engage the retaining clips.
16. Install the screws.
17. Install the screws.
18. Install the screws.
19. Install the console lid and the screw.
20. Install the console insert and the screws.
21. Install the coin tray.
22. Install the floor console.