Mustang

1. NOTE: The IMRC valve will reset itself when the vehicle is started.

Reaching behind the left side of the engine, manually open the IMRC valve by grasping the left IMRC actuation rod and pulling it toward the driver side of the vehicle.

2. WARNING: USE LATEX GLOVES TO AVOID DIRECT SKIN CONTACT WITH THE THREADLOCK AGENT. IF THREADLOCK AGENT DOES COME INTO DIRECT CONTACT WITH EXPOSED SKIN, THOROUGHLY WASH THE AFFECTED AREA WITH SOAP AND WATER. PLEASE REFER TO THE PRODUCT LABEL FOR ADDITIONAL HEALTH WARNINGS.

Attach an approximately 46-51cm (18-20 in.) length of rubber hose to the tip of the supplied bottle of threadlock agent. You may use either washer fluid hose (part number D3PZ-17543-B) or an equivalent hose with an inside diameter of 1.6-3.2 mm (1/16-1/8 in.).

3. Locate the left side set screw and apply enough of the threadlock agent to completely cover the IMRC set screw.

4. Locate the right side set screw and apply enough of the thread lock agent to completely cover the IMRC set screw.

5. Close the hood.

6. Allow the threadlock agent to cure for 30 minutes before starting the vehicle.