Cruise Control Servo: Service and Repair

REMOVAL
1. Disconnect the battery ground cable.







2. Disconnect the speed control servo electrical connector.







3. Remove the speed control cable cap from the speed control servo.
^ Push in the locking arm on the speed control cable cap then rotate the cap counterclockwise.







4. Remove the speed control cable.
1 Depress the spring retainer.
2 Slide the core wire end out of the speed control servo pulley and remove the speed control cable.







5. Remove the speed control servo bracket bolt and remove the servo.







6. Remove the bolts and separate the speed control servo bracket from the speed control servo.

INSTALLATION
1. To install, reverse the removal procedure.

NOTE: Make sure the rubber seal is fully seated onto the speed control cable cap.