Fuel Tank Pressure Sensor: Service and Repair

REMOVAL

NOTE: 2.5L shown. For 2.3L, 3.0L and 4.0L engines, the fuel tank pressure sensor is located in the vapor line assembly. A new vapor line assembly must be installed for a new pressure sensor to be installed.

1. Remove the fuel tank.

CAUTION: The fuel tank pressure sensor must be disengaged from the fuel tank before it can be removed. Failure to do so can cause damage to the fuel tank pressure sensor or the fuel tank.







2. Remove the fuel tank pressure sensor.
1 Disconnect the electrical connector.
2 Press down and rotate the fuel tank pressure sensor counterclockwise and remove it from the fuel tank.

INSTALLATION
1. To install, reverse the removal procedure.
^ Carry out the leak test. Evaporative Emission System Leak Test
^ Carry out the evaporative emission repair verification drive cycle. Drive Cycles