RH

Valve Cover RH

Removal
1. Remove the upper intake manifold.





2. Remove the RH coils-on-plug.
1 Disconnect the three electrical connectors.
2 Remove the three bolts.
3 Remove the coil.





3. Remove the wiring harness nuts and disconnect the (02) sensor electrical connectors.





4. Remove the radio ignition interference capacitor.





5. Separate the harness from the center locating pins and position aside.





6. Disconnect the crankcase ventilation tube from the valve cover.





7. Remove the bolts, studs and the RH valve cover.
- Install the new gasket if damaged.

Installation

NOTE: The valve cover must be installed and the bolts tightened within six minutes of applying the sealant.

1. Install a new valve cover gasket if damaged.





2. Apply a 5 mm dot of Silicone Gasket Sealant F7AZ-19554-EA or equivalent meeting Ford specification WSE-M4G323-A4 to the front cover to cylinder head joints.





3. Position the valve cover and install the bolt and the studs in the sequence shown.





4. Connect the crankcase ventilation tube to the valve cover.





5. Connect the radio ignition interference capacitor.





6. Connect the (02) sensor electrical connectors and wiring harness to the RH valve cover stud.





7. Install the RH coils-on-plug.
1 Position the coils.
2 Install the three bolts.
3 Connect the electrical connectors.
8. Install the upper intake manifold.