Torque

A/C compressor bolts		18 ft. lbs.
A/C line nut		71 inch lbs.
A/C to water pump bracket bolts		18 ft. lbs.
Accessory drive belt tensioner bolt		18 ft. lbs.
LH - Camshaft Cap Bolts		89 Inch lbs.
RH - Camshaft cap bolts		89 inch lbs.
Camshaft oil seal retainer bolts		89 inch lbs.
Camshaft position sensor bolt		89 inch lbs.
Connecting Rod Cap Bolts	Stage 1	17 ft. lbs.
	Stage 2	32 ft. lbs.
Cooler line bracket bolt		18 ft. lbs.
Crankshaft position sensor bolt		inch lbs.
Crankshaft pulley	Stage 1	89 ft. lbs.
	Stage 2	Loosen 360°
	Stage 3	37 ft. lbs.
	Stage 4	Additional 90°
Crankshaft pulley bracket nuts		18 ft. lbs.
Cylinder head bolts-LH NOTE: The cylinder head bolts must be replaced with new bolts. They are torque-to-yield designed and cannot be reused.	Stage 1	30 ft. lbs.
	Stage 2	90°
	Stage 3	Loosen one full turn
	Stage 4	30 ft. lbs.
	Stage 5	90°
	Stage 6	90°
Cylinder head bolts-RH NOTE: The cylinder head bolts must be replaced with new bolts. They are torque-to-yield designed and cannot be reused.	Stage 1	30 ft. lbs.
	Stage 2	90°
	Stage 3	Loosen one full turn
	Stage 4	30 ft. lbs.
	Stage 5	90°
	Stage 6	90°
Exhaust gas recirculation (EGR) tube nuts		30 ft. lbs.
EGR valve bolts		18 ft. lbs.
Engine front cover bolts and studs		18 ft. lbs.
EGR vacuum regulator tube nuts		53 inch lbs.
Exhaust bracket nut		30 ft. lbs.
Flexplate bolts		59 ft. lbs.
Ball joint nuts		59 ft. lbs.
Front splash shield bolts		62 inch lbs.
Fuel charging harness nut		53 inch lbs.
Fuel rail bolts		89 inch lbs.
Generator bolts and studs		35 ft. lbs.
Ground strap bolt		11 ft. lbs.
Halfshaft nuts		191 ft. lbs.
Halfshaft bracket bolts		35 ft. lbs.
Heater hose bracket nuts		62 inch lbs.
Ignition coil-on-plug bolts		53 inch lbs.
Knock sensor bolt		13 ft. lbs.
LH engine support insulator bolts		52 ft. lbs.
LH engine support insulator nut		66 ft. lbs.
LH exhaust manifold nuts		15 ft. lbs.
Lower cylinder block bolts and studs	Stage 1	18 ft. lbs. Fasteners 1-8
	Stage 2	30 ft. lbs. Fasteners 9-19
	Stage 3	90° fasteners 1-16
	Stage 4	18 ft.lbs. Fasteners 17-22
Lower intake manifold bolts		89 inch lbs.
Motor mount bracket bolts/nuts		76 ft. lbs.
Oil level indicator and tube stud		89 inch lbs.
Oil pan baffle nuts	Stage 1	44 inch lbs.
	Stage 2	45°
Oil pan bolts and studs		18 ft. lbs.
Oil pan to transaxle bolts		30 ft. lbs.
Oil pressure sensor		10 ft. lbs.
Oil pump bolts		89 inch lbs.
Oil pump screen and pick up tube bolts	Stage 1	44 inch lbs.
	Stage 2	45°
Oil separator bolts		89 inch lbs.
Outer tie rod end nuts		41 ft. lbs.
Power steering pump bolts		18 ft. lbs.
Power steering pressure line bracket nut		89 inch lbs.
Power steering pressure line nut		27 ft. lbs.
Powertrain control module (PCM) electrical connector bolt		53 inch lbs.
Power distribution box cable nuts		9 ft. lbs.
Radiator fan bolt		89 inch lbs.
RH engine support insulator nut		66 ft. lbs.
RH engine support insulator through bolt and nut		89 ft. lbs.
RH exhaust manifold nuts		15 ft. lbs.
RH radio ignition interference capacitor nut		89 inch lbs.
Shifter cable nut		13 ft. lbs.
Starter motor ground cable bolt		18 ft. lbs.
Starter cable positive nut		9 ft. lbs.
Steering shaft pinch bolt		30 ft. lbs.
Strut to knuckle bolts		85 ft. lbs.
Subframe bolts		148 ft. lbs.
Subframe nuts		111 ft. lbs.
Transaxle mount bolts		41 ft. lbs.
Transaxle mount through bolt		66 ft. lbs.
Sway bar end link nuts		35 ft. lbs.
Throttle body bolt and stud		89 inch lbs.
Timing chain guide bolts		18 ft. lbs.
Timing chain tensioner bolts		18 ft. lbs.
Torque converter to flexplate nuts		30 ft. lbs.
Transaxle to oil pan bracket bolt		18 ft. lbs.
Transaxle to oil pan bracket nuts		89 inch lbs.
Upper intake manifold bolts		89 inch lbs.
Valve cover bolts and studs		89 inch lbs.
Water pump bolts		18 ft. lbs.
Wire harness bolt		44 inch lbs.
Y-pipe nuts		30 ft. lbs.
Y-pipe to exhaust manifold nuts		30 ft. lbs.