Injector Driver Module: Service and Repair

REMOVAL
1. Turn the ignition switch to the OFF position.

WARNING: ELECTRIC SHOCK. HIGH VOLTAGE WIRES ARE INSIDE THE RED-STRIPED WIRE HARNESS. YOU MAY RECEIVE A SEVERE ELECTRICAL SHOCK IF THE WIRES ARE PIERCED. DO NOT PIERCE.

CAUTION:
^ Do not pierce engine electrical wires or damage to the harness can occur.
^ Make sure the ignition switch is in the OFF position prior to working on the electronic engine controls.

2. Raise and support the vehicle.







3. Remove the driver side splash guard.
1 Remove the screws.
2 Remove the splash guard.







4. Remove the module.
1 Loosen the connector bolt.
2 Remove the wire connector.
3 Remove the two retaining bolts.
4 Remove the module.

INSTALLATION







1. Follow the removal procedure in reverse order.