Rear Quarter Trim Panel

Safety Belt Bolt Bit:

SPECIAL TOOL(S)

REMOVAL







1. Remove the windshield side garnish moulding.







2. Remove the scuff plate.







3. Remove the front shoulder safety belt guide bolt cover.

NOTE: Inspect the shoulder safety belt guide cover for damage. If the shoulder safety belt guide cover is damaged or if it does not remain closed, install a new shoulder safety belt guide cover.







4. Using the special tool, remove the front shoulder safety belt guide bolt.
5. Position the carpet aside.







6. Using the special tool, remove the front safety belt anchor bolt.







7. If equipped, remove the retractable cargo cover.
8. Remove the liftgate scuff plate.
9. Fold the rear seat into the load floor position.







10. Using the special tool, remove the rear shoulder safety belt guide bolt.
11. Position the carpet aside.







12. Using the special tool, remove the rear safety belt anchor bolt.







13. Remove the rear quarter window latch screws.







14. Remove the coat hook.
1 Remove the screw.
2 Remove the coat hook.







15. Remove the quarter trim panel front screw.
- Position the carpet aside to gain access to the screw.







16. Remove the three quarter trim panel rear screws.
- Position the carpet aside to gain access to the screws.







17. If equipped, remove the rear door lock control switch assembly.
- Disconnect the electrical connector.







18. Remove the quarter trim panel.
1 Remove the eight pin-type retainers.
2 Feed the safety belt webbing through the opening in the quarter trim panel.
3 Remove the quarter trim panel.

INSTALLATION
1. To install, reverse the removal procedure.