Without Side Air Bag

DISASSEMBLY
1. Remove the seat cushion.







2. Disconnect the seat backrest recliner actuator.
1 Remove the screws.
2 Disconnect the seat backrest recliner actuator.







3. Remove the seat cushion frame from the seat cushion foam.
1 Unhook the seat cushion trim cover J-clips.
2 Remove the seat cushion frame from the seat cushion foam.







4. Invert the seat cushion trim cover.
5. Remove the swing rod to tie-down wire hog rings from the side swing rods (one on each side).







6. Remove and discard the hog rings.
1 Fold back the seat cushion trim cover to expose the hog rings.
2 Remove and discard the hog rings on the front and side trenches.

NOTE: The hog rings along the front of the seat are shown, the hog rings along either side are similar.

7. Remove the swing rods.







8. Remove the power seat wiring harness.
1 Disconnect the pin-type retainers.
2 Remove the power seat wiring harness.







9. Remove the flexilator.
1 Remove the flexilator springs.
2 Remove the flexilator.







10. Remove the seat backrest recliner roll pins and remove the seat backrest recliners.







11. Disconnect the seat backrest recliners from the seat backrest recliner actuator.
1 Disconnect the seat backrest recliner actuator cable housings from the seat backrest recliners.
2 Unhook the seat backrest recliner actuator cables from the seat backrest recliners.

ASSEMBLY







1. Connect the seat backrest recliners to the seat backrest recliner actuator.
1 Hook the seat backrest recliner actuator cables to the seat backrest recliners.
2 Connect the seat backrest recliner actuator cable housings to the seat backrest recliners.







2. Install the seat backrest recliner roll pins.







3. Install the flexilator.
1 Position the flexilator.
2 Install the flexilator springs.







4. Install the power seat wiring harness.
1 Position the power seat wiring harness.
2 Install the pin-type retainers.
5. Install the front swing rod.
6. Install the swing rods.

NOTE: Make sure the swing rods are seated under the boarder wire in the foam near the back of the seat cushion.







7. Install the hog rings.
1 Fold back the seat cushion trim cover to the hog ring installation position.
2 Hog ring the center of the front swing rod to the tie-down rod in the seat cushion.
3 Hog ring the front swing rod to tie-down wire outboard sides.

NOTE: The hog rings along the front of the seat are shown; the hog rings along either side are similar.

8. Hog ring the side swing rods (one on each side) to the tie-down wire.







9. Invert the seat cushion trim cover.







10. Set the hook and loop fasteners.
11. Install the seat cushion foam to the seat cushion frame.







12. Install the seat cushion frame.
1 Position the seat cushion frame.
2 Hook the seat cushion trim cover J-clips.







13. Connect the seat backrest recliner actuator.
1 Connect the seat backrest recliner actuator.
2 Install the screws.
- Tighten until the screws are fully seated.
14. Install the seat cushion.