Cruise Control Servo Cable: Service and Repair

REMOVAL

Early production vehicles







1. Remove the accelerator cable snow shield.
1 Detach the cable.
2 Remove the bolts.
3 Remove the accelerator cable snow shield.







2. Separate the speed control cable from the intake manifold.
1 Remove the bolt.
2 Disconnect the cable from the throttle linkage.

Late production vehicles







3. Remove the bolts and the accelerator cable snow shield.







4. Separate the speed control cable from the intake manifold.
1 Disconnect the cable from the throttle linkage.
2 Depress the locking tabs and separate the speed control cable from the intake manifold.

All vehicles







5. Depress the locking tab and rotate the speed control cable cap to remove.







6. Disconnect the speed control cable from the speed control servo pulley and remove the speed control cable.
1 Gently push the retaining spring.
2 Disconnect the speed control cable slug from the speed control servo pulley.

INSTALLATION







1. To install, reverse the removal procedure.
^ On early production vehicles, adjust the speed control cable.

NOTE: Make sure the rubber seal is fully seated onto the speed control cable cap