Front Band Adjustment
Front Band AdjustmentSpecial Tools:
Special Tool(s)
1. Raise the vehicle on a hoist.
2. Disconnect the shift cable.
1 Disconnect the shift cable from the manual control lever.
2 Disconnect the shift cable from the bracket.
3. CAUTION: Do not allow front band adjustment screw to back out. Band strut can fall out of position.
CAUTION: Throw the locknut away. The locknut is not reusable for assembly.
Remove and discard the locknut.
4. CAUTION: Install, but do not tighten, a new locknut on the band adjustment screw. Apply petroleum jelly to the locknut seal.
CAUTION: The servo must be installed prior to band adjustment.
NOTE: The wrench will click at the specified torque. Install new locknut, do not tighten at this time.
Using the special tool, tighten front band adjustment screw then, back off the front band adjustment screw exactly two (2) turns and hold that position.
5. Tighten the front band locknut.
1 Hold the front band adjustment screw stationary.
2 Tighten the front band locknut.
6. Install the shift cable.
1 Install the shift cable.
2 Install the shift cable to the manual control lever.
7. Lower the vehicle.