Power Locks: Service and Repair

Remote Transmitter Programming






SPECIAL TOOL(S)

NOTE:
^ All remote transmitters are programmable and must be set at the same time.
^ To program (or reprogram) the remote transmitters into the Remote Keyless Entry (RKE), carry out the following steps:

1. Connect the New Generation STAR/Service Bay Diagnostic System (diagnostic tool/SBDS) tester. Turn the ignition from OFF to RUN.
2. From diagnostic tool/SBDS: Using the Ford Service Function (FSF) card, select SERVICE BAY FUNCTION.
3. Select RKE.
4. Select KEY FOB PROGRAMMING.
5. Press any button on the remote transmitter.
6. Select the FOB 1, 2, 3, or 4, and select STORE. It may be necessary to select CANCEL more than once to exit the menu.
7. Repeat Steps 5 and 6 for additional transmitters.
8. Select CANCEL to exit the menu.

NOTE: It may be necessary to select CANCEL more than once to exit the menu.