Removal and Installation

BATTERY - 4.6L (2V)

WARNING: When lifting a plastic-cased battery, excessive pressure on the end walls could cause acid to spew through the vent caps resulting in personal injury, damage to the vehicle or to the battery. Lift with a battery carrier or with your hands on opposite corners.

REMOVAL
1. Disconnect the battery.







2. To remove individual components, only carry out the steps.

View 1 Of 2, Part 1:

View 1 Of 2, Part 2:

3. View 1 of 2. Remove the components in the order indicated in the illustration and table.

View 2 Of 2, Part 1:

View 2 Of 2, Part 2:

4. View 2 of 2. Remove the components in the order indicated in the illustration and table.

Item 1: Starter Solenoid Terminals Protective Cap Removal Note
1. Raise and support the vehicle.

Item 12: Battery Cable Bracket And Engine Ground Cable Nuts Removal Note
1. Lower the vehicle.

Item 18: Generator B+ Terminal Nut Removal Note
1. Position the generator B+ terminal protective cover aside.

Item 23: Battery Junction Box Nut Removal Note
1. Open the battery junction box cover to access the battery junction box nut.

INSTALLATION
1. To install, reverse the removal procedure.