Passenger Seat
PASSENGER SEATSeat Belt Bolt Bit:
SPECIAL TOOL(S)
REMOVAL
All vehicles
1. Position the front passenger seat rearward.
2. Remove the passenger seat front track-to-floor bolts.
3. Position the front passenger seat forward.
Vehicles with power seats
4. Disconnect the battery ground cable.
5. Disconnect the power seat electrical connector.
All vehicles
6. Remove the safety belt buckle support bolt cover plug.
7. Using the special tool, remove the safety belt buckle support bolt.
8. Remove the passenger seat rear bolt trim covers.
9. Remove the passenger seat rear bolts.
10. CAUTION: Use care when handling the seat and track assembly. Dropping the assembly or sitting on a seat not secured in the vehicle may result in damaged components.
Remove the passenger seat from the vehicle.
INSTALLATION
All vehicles
1. Position the seat into the vehicle. Install all the seat track-to-floor bolts and hand-tighten them.
Vehicles with power seats
2. Connect the power seat electrical connector.
3. Connect the battery ground cable.
All vehicles
4. Position the seat rearward.
5. Tighten the seat front track-to-floor bolts in sequence shown.
1 Tighten the front inboard bolt.
2 Tighten the front outboard bolt.
6. Position the seat forward.
7. Tighten the seat rear track-to-floor bolts in sequence shown.
1 Tighten the rear inboard bolt.
2 Tighten the rear outboard bolt.
8. Install the rear track bolt covers.
9. Using the special tool, install the safety belt buckle bolt.
10. Install the safety belt buckle support bolt cover.
11. Check the active restraint system for correct operation.