Rear Door Window Glass: Service and Repair

REAR DOOR WINDOW GLASS

Heavy Duty Riveter:

SPECIAL TOOL(S)

REMOVAL
1. Remove the rear door trim panel.







2. Remove the interior glass weatherstrip.







3. Remove the rear door belt line moulding nut.







4. CAUTION: Do not strike or force the rear door belt line moulding during the installation. The rear door belt line moulding is made of aluminum and will be damaged.

NOTE: During installation, make sure that the rear door belt line moulding fits flush with the edge of the sheet metal and the door panel shelf.

Remove the rear door belt line moulding.







5. Position aside the water shield.







6. Connect the power window switch.







7. Remove the rear door window glass rivets.
- Lower the glass approximately two-inches to access the rivets through the holes.

8. Carefully lower the window regulator while holding the glass.
- Lower the glass.







9. Separate the front of the window run/weatherstrip from the door.
10. Remove the rear door window glass through the outboard side of the rear door.

INSTALLATION
1. To install, reverse the removal procedure.
- Use the special tool to install the rivets.