4 Wheel Antilock Control

Anti-Lock Brake System (ABS) Module

Removal and Installation

1. CAUTION: Electronic modules are sensitive to static electrical charges. If exposed to these charges, damage may result.

Disconnect the battery ground cable.





2. Disconnect the anti-lock brake control module electrical connector.





3. Disconnect the pump motor electrical connector from the anti-lock brake control module.





4. Remove the screws and the anti-lock brake control module.

5. NOTE: At the first key-on after a new ABS module is installed, use the NGS with the service card to configure the module.

To install, reverse the removal procedure.


To install, reverse the removal procedure.