With Manufacturer's Scan Tool (WDS or NGS Tester)

On-Board Diagnostics with Diagnostic Tool

NOTE: For detailed instruction and other diagnostic methods using the scan tool, refer to the NGS Tester Manual and Computers and Control Systems / Testing and Inspection. Testing and Inspection

These quick tests should be used to diagnose the powertrain control module (PCM) and should be carried out in order.
- Quick Test 1.0-Visual Inspection
- Quick Test 2.0-Set Up
- Quick Test 3.0-Key On, Engine Off (KOEO)
- Quick Test 4.0-Continuous Memory
- Quick Test 5.0-Key On, Engine Running (KOER)
- Special Test Mode
- Wiggle Test
- Output Test Mode
- Output State Control Mode

- PCM Reset Mode
- Clearing DTCs
- OBD II Drive Cycle
- Other NGS Features
- Other diagnostic methods include the following.
- Parameter Identification (PID) Access Mode
- Freeze Frame Data Access Mode
- Oxygen Sensor Monitor Mode