Handles, Locks, Latches and Entry Systems
HANDLES, LOCKS, LATCHES AND ENTRY SYSTEMSThe hood consists of the following components:
- hood latch striker
- hood latch
- hood latch release handle and cable
The front doors consists of the following components:
- front door latch push button rods
- exterior door handles
- front door latches (manual locks)
- front door latches (power locks)
- interior door handles
- door lock cylinders
- door ajar switches
- door lock control switches
The rear doors consists of the following components:
- exterior door handles
- rear door upper latches
- rear door lower latches
- interior door handles
- door ajar switches
The tailgate consists of the following components:
- tailgate latch
- tailgate cables
- tailgate latch remote control
- tailgate release handle
Keyless Entry
The keyless entry system consists of the following components:
- keyless entry remote transmitter
- central security module
- driver unlock relay
- all unlock relay
- all lock relay
The keyless entry remote transmitter initiates the following electronic door lock system functions:
- unlocks the driver door
- unlocks all doors
- locks all doors
- activate/deactivate the panic alarm
- commands the interior lamps on (when unlocking) and off (when locking)
- sounds the horn once when LOCK is pressed twice within three seconds and doors are closed
- sounds the horn twice when LOCK is pressed twice within three seconds and any door is ajar
NOTE:
- The panic alarm feature only operates when the key is OFF.
- The LOCK and UNLOCK buttons on the remote transmitter operate independent of ignition status.
The keyless entry remote transmitters (up to four) are reprogrammable and must be set at the same time.
To confirm that the doors have been locked, press the LOCK button again within three seconds of the first press. The lamps will flash if the doors have locked and all doors are closed.
To activate the panic alarm:
- Press the red PANIC button on the keyless entry remote transmitter. The horn will sound and the parking lamps will flash for a maximum of 2 minutes and 45 seconds.
To deactivate the panic alarm:
- Press the red PANIC button on the keyless entry remote transmitter.
- Turn the key to RUN/START.
Power Unlock Inhibit
With the key OFF, 20 seconds after electrically locked (key fob, keypad, door lock control switch locked with door ajar) and all doors are closed, the power door unlock switch will be inhibited if this feature is enabled. (the lock function will still operate.)
Deactivating/Activating Power Door Unlock Switch Inhibit
This is dealer configurable and can be enabled/disabled using a diagnostic tool.