Spark Plug: Service and Repair

Spark Plug Wire Remover:

SPECIAL TOOL(S)

REMOVAL

Spark Plug Wire Remover:

1. Use the special tool with a twisting motion to pull the spark plug wire off the spark plugs.

CAUTION:
^ Spark plug wires must be connected to the correct ignition coil terminal.
^ It is important to twist the spark plug wire boots while pulling upward to avoid damage to the spark plug wire.







2. Remove the spark plug.

NOTE:
^ Use compressed air to remove any foreign materials from the spark plug well before removing the spark plugs.
^ If an original spark plug is reused, make sure it is placed in the same cylinder from which it was taken. New spark plugs can be used in any cylinder.

3. Inspect the spark plugs.

INSTALLATION







1. To install, reverse the removal procedure.
^ Adjust the spark plug gap as necessary.